HOWTO Wiki Throttle Ratchet Mod
From Heli-Wiki
The Throttle Ratchet Mod
--Beenie 07:35, 30 March 2007 (EDT) For the Stock Blade CP Receiver
First take the 4 screws in the back out.
Be careful not to rip of any wires, especially the yellow wire in the picture below.
Cut some rubber tubing – about 2 inches
Note: If you're wondering where the cool coil that is around the servo wires came from Bbrooks found it at the Home Depot in the electrical wiring section.
The throttle ratchet
Put the tube over the metal ratchet.
Put the back piece back on and screw your four screws back in
Now you have a smooth throttle ratchet
